CHASSIS · 720S
MCLAREN 720S
in Carbon Fiber
Front blade splitters, shark fins and rear extractors developed on a real McLaren 720S MonoCage II. Each piece is laminated in Twill 2x2 or Forged carbon and finished by hand in Italy.
PROGRAMME · 720S
Carbon on a
carbon monocoque.
The 720S was conceived around the MonoCage II — a single-piece carbon tub. Our exterior pieces honour that intent: structural weave, tight panel gaps, finishes that align with the original visible-carbon options.
Lay-up
Prepreg
Cure
Autoclave
Finish
Twill or Forged
Filters
5 items
Sort Featured
-
Front Blade Splitter in Carbon Fiber - McLAREN 720S
Front Blade Splitter in Carbon Fiber - McLAREN 720S
-
€3.904,00Taxes included. Shipping calculated at checkout. -
Rear Trunk Fin Shark in Carbon Fiber - MCLAREN 720S
Rear Trunk Fin Shark in Carbon Fiber - MCLAREN 720S
-
€3.660,00Taxes included. Shipping calculated at checkout. -
Rear Extractor Fins in Carbon Fiber - MCLAREN 720S
Rear Extractor Fins in Carbon Fiber - MCLAREN 720S
-
€2.196,00Taxes included. Shipping calculated at checkout. -
License Car Plate Holder in Forged Carbon by RSI c6
License Car Plate Holder in Forged Carbon by RSI c6
-
€219,60Taxes included. Shipping calculated at checkout. -
License Car Plate Holder in Carbon Fiber by RSI c6
License Car Plate Holder in Carbon Fiber by RSI c6
-
€183,00Taxes included. Shipping calculated at checkout.
TECHNICAL DOSSIER · 03
Two finishes,
one philosophy.
TWILL
Carbon Fiber
Classic woven pattern.
Reads as a regular, directional weave under light. Available gloss or matte.
Resin
Epoxy
UV-stabilised epoxy system.
Clear-coated for long-term gloss retention and stone-chip resistance.
FORGED
Forged Carbon
Random short-fibre lay-up cured under pressure.
Marbled, organic figure with no two pieces alike.
Tolerance
± 0.4 mm
Trim-line tolerance verified on a CMM jig
before each part leaves the atelier.